Why is the power panel on my DSC not working?

The following applies to all PowerSeries panels, which include PC1616, PC1832, PC5010, PC5015 and others. AC power is not present at the panel (the system is operating on stand-by battery power. The panel does not detect an active telephone line. The system attempted to communicate with the monitoring station but failed.

What are the trouble codes on my DSC?

DSC uses LED codes to indicate trouble details for all keypads that don’t have an LCD readout display. The following applies to all PowerSeries panels, which include PC1616, PC1832, PC5010, PC5015 and others. AC power is not present at the panel (the system is operating on stand-by battery power.

How can I get my DSC Alarm back to normal?

These simple steps will have your alarm system back to normal in less than 5 minutes! Open the access door and enter your master code twice. Pull down the panel that covers the keypad on your alarm system. After this, simply enter your 4 digit master code, wait 2 seconds, and then enter it again.

What kind of keypad does a DSc panel have?

However, if you use DSC model PC4020, which has an LCD keypad with fixed displays, instead of displaying numbers, it will spell out the trouble condition. To download a copy for your panel model, go to the User Manual section of the DSC website and find the model of your panel.

What is the installer code for DSC power?

You will then be asked to enter Installer code .. Enter 5555 The keypad should beep and then ask you for ‘Section’ again .. Enter 999 again NOTE: If using an LED or PK5501 keypad, you will not see a display or any numbers during your programming. You have to listen for the beeps.

Can a DSc alarm system run off of battery power?

Hunker may earn compensation through affiliate links in this story. A DSC alarm system should run off of battery power for several hours during a power outage, but if you have a longer period of downtime, the batteries can be drained. When that happens, you will need to reset the sensors using the keypad on the control unit.

How to enter programming 8-5555 DSC power series?

Enter Programming *8-5555- Enter section 898. Each wireless device needs to be recognized by the control panel. We call this Enrollment. For this Section we will be triggering (open/close or tamper) each device. If the devices are in front of you, you will take the magnet (small piece) away from the transmitter (bigger piece) and put back together.

Do you have to default to quick start on DSC power?

WE DO NOT RECOMMEND BEING IN ANY SECTION OF YOUR SYSTEM UNLESS IT IS ON THIS QUICK START GUIDE. Doing so may cause problems in the function of your alarm system. Even though your system comes factory defaulted; we suggest that you default the system just to make sure you have a clean slate to work with.