Why is my car connected to Bluetooth but no sound?

If the volume on the Bluetooth® car stereo is set to a high level but there is either low or no sound during a phone call, there may be an incorrect setting or a problem with your hookup. Try adjusting the volume on the car stereo receiver, just to make sure the volume was not set to a low level.

How do I update my Jensen VX7022?

Note: These update instructions are only a general guide….Beginning the Update

1. Before starting the update, ensure the VX7022 is OFF (Press and hold the volume control).
2. Remove the navigation MicroSD card from the unit and set aside.
3. Turn ON the vehicle ignition.
4. The update process will begin automatically upon power up.

How do I reset my Jensen vx2529?

Press the house icon in the top left corner to access the Main Menu screen. Use the arrows in the bottom corners to navigate to the next or previous screen. To resolve abnormal operation or if the unit is inoperable, use the tip of a pen to press the RESET button.

Why is my Jensen radio not pairing with my phone?

My method is to select the Bluetooth mode, then hold enter down for 3 seconds, then Pairing appears on the Jensen screen but no device can connect. I have also tried the Reset on the Menu, tried turning Bluetooth and my phone and the radio off and on again, but my phone does not even see the JWN device anymore. ” Not all that wander are lost …”

Where is the reset button on a Jensen stereo?

If you’re having problems with your Jensen stereo, there are a few things you can do to troubleshoot. Press the “Reset” button if the unit won’t power on. It’s often located on the bottom right corner of the front panel. Turn the car’s ignition key to the “Accessory” position.

Why does my Jensen coach not work with Bluetooth?

If it’s possible, you could try cutting all of the power to the Jensen, then try again. Not sure how you could do that other than to shut down your electric (e.g. unplugged from 110 volt), then hit your battery disconnect so all power is shut off from the coach.

What to do if your car stereo has no sound?

Radios have all sorts of wires going in and out of them. Each wire serves a specific purpose for the car stereo to operate correctly. If you have a car stereo that has no sound than we should start by checking that all the wires are hooked up. A car stereo will always have 3 different power wires going to the deck section.

How to get Jensen radio to pair with Bluetooth?

Now press and hold the menu button to enter system setup. Press menu until Bluetooth device shows up and press enter to select. Now press and hold enter to get it to seek your device. Go to your phone and select JWM9A under Bluetooth This is the only way that I can get it to pair when the normal method does not work.

What to do if your Jensen Stereo is not working?

Install a fresh set of batteries in the remote control if you are unable to deselect “Mute,” or if your Jensen stereo doesn’t appear to function correctly. Verify that the video display’s “Automatic Open” feature is selected if the monitor doesn’t open automatically when you turn the equipment on.

If it’s possible, you could try cutting all of the power to the Jensen, then try again. Not sure how you could do that other than to shut down your electric (e.g. unplugged from 110 volt), then hit your battery disconnect so all power is shut off from the coach.

Where is the reset button on a Jensen?

Press the “Reset” button if the unit won’t power on. It’s often located on the bottom right corner of the front panel. Turn the car’s ignition key to the “Accessory” position. Adjust the speaker settings to the center position if there’s an excessive audio emphasis to the left or right, front or back.