Why does my Swann camera Say No HDD?

If the HDD is still not detected, you may need to open the case of the DVR to check that all the cables are correctly connected to the HDD. Unplug the DVR from power, unscrew the necessary screws, and remove the casing of the DVR. Place the case back on the DVR and plug the power cable back into the DVR.

Where is the model number on a Swann?

You must go to Settings (at the lower right) then select your device (if you only have 1x Swann unit, it will automatically select that device). Swipe all the way to the bottom then tap on Technical Details then check the Model.

How do I get notifications on my Swann DVR?

Tap the Gear icon at the top right. After enabling notifications on the app, go to DVR/NVR Main Menu > Alarm > Detection > Actions and make sure the ‘Push’ option is ticked on the corresponding camera channels for which you want to receive Swann Security app notifications, as shown above.

How old is my Swann DVR in years?

I have a Swann dvr 161580, s/no. 29264091602190 it is about 2 years old. Iam trying to go back about 1 1/2 years to get a vido of a person that committed a crime. Is this possiable ?  read more Russell H.

Can a Swann DVR be connected to a laptop?

If your Swann DVR is connected on your network just like the diagram below, this method can work for you as long as you have a computer or laptop. Guest what…. you computer, router and everything else in the network have also have their own MAC ADDRESS.

What to do if you lost your Swann DVR password?

If you lost the Swann DVR password, here you will learn how to reset the DVR by using a code (swann dvr mac address). You only need to use a mobile phone, tablet or computer and follow simple instructions. This is a Swann factory reset procedure that works for the models 4350,…

How to reset a Swann DVR with a paper clip?

4) With the BATTERY OUT Using a short piece of wire or a paper clip, SHORT OUT the battery terminals on the circuit board for 30 seconds to drain the system’s capacitors5) Re install the button battery and turn unit ON.

I have a Swann dvr 161580, s/no. 29264091602190 it is about 2 years old. Iam trying to go back about 1 1/2 years to get a vido of a person that committed a crime. Is this possiable ?  read more Russell H.

How to reset a Swann DVR to factory admin codes?

4) With the BATTERY OUT Using a short piece of wire or a paper clip, SHORT OUT the battery terminals on the circuit board for 30 seconds to drain the system’s capacitors 5) Re install the button battery and turn unit ON. This *should * reset the DVR to factory admin codes, which is 123456

Where to get the model number of your Swann unit?

To get the model number of your Swann unit, you must first identify what kind of unit do you have To get the model number of your system, you can check any of the following: For recorders, you can check it underneath the code usually starts with SW or SR followed by DVR or NVR then a ‘dash’ or ‘hyphen’ then some numbers.

Where do I find the Swann security code?

This code is located at the bottom of the box. This method is only applicable to units that use Swann Security app and if it has been paired on the Swann Security account. You must go to Settings (at the lower right) then select your device (if you only have 1x Swann unit, it will automatically select that device).