Which is the factory default for the NX-4?
Which is the factory default for the NX-4?
The factory default for User #1 is [ 1]-[2]-[3]-[4] when using a 4-digit code, or [ 1]-[2]- [3]-[4]-[5]-[6] for a 6-digit code. This code can then be used to enter the new arm/disarm codes. (Loc. 41, page 19) Automatic Arming If programmed, the NX-4 will Auto Arm at the time specified in location 53.
How to reset master code for Networx series NX-4?
Power down for a minute then power back up (AC first) then go to keypad and enter 971300. CAREFUL this will default the whole panel and you will need the manual and minor skill to re-programme it. It will revert the panel settings back to factory default. These settings are quite useable for most domestic situations.
How does the Cancel button work on the NX-4?
If enabled, the NX-4 will wait the programmed number of seconds in location 40 prior to sending an alarm. During this delay time, the “Cancel” LED will flash. To abort the report, type in a code and press the [Cancel] key. The LED will extinguish.
Is the Networx NX-4 control panel user friendly?
The NetworX NX-4 represents a new approach to security systems design. Drawing on our experience in the world market as the largest exporter of USA manufactured controls we have developed the most flexible, durable, and user- friendly control ever seen in our industry.
What is the Networx nx-4v2 control panel?
The NetworX NX-4V2 represents a new approach to security systems design. Drawing on our experience in the world market as the largest exporter of USA manufactured controls, we have developed the most flexible, durable, and user-friendly control ever see n in our industry.
The factory default for User #1 is [ 1]-[2]-[3]-[4] when using a 4-digit code, or [ 1]-[2]- [3]-[4]-[5]-[6] for a 6-digit code. This code can then be used to enter the new arm/disarm codes. (Loc. 41, page 19) Automatic Arming If programmed, the NX-4 will Auto Arm at the time specified in location 53.
Power down for a minute then power back up (AC first) then go to keypad and enter 971300. CAREFUL this will default the whole panel and you will need the manual and minor skill to re-programme it. It will revert the panel settings back to factory default. These settings are quite useable for most domestic situations.
When to arm the NX-4 control panel?
The NX- 4 will attempt to arm after every 45 minutes of inactivity until the next [email protected] time (loc. 52), or until the system is armed. The 45-minute timer will be extended when there is activity in the building causing the “Ready” LED to turn off and on. If closing reports are sent, the user code will be 97.
