When to turn off the standby switch on an amp?
When to turn off the standby switch on an amp?
For short breaks, simply turn down the volume control (or mute switch if you have one) and don’t use the standby switch, so there is not that nasty pop in the house sound system that could damage speaker drivers. If the time between sound check and performing is longer than 20 minutes, turn the amplifier completely off.
Why is my CMT sbt100b amplifier not standing up?
CMT-SBT100B amplifier power-up problem – STANDBY b… Problem: On power-up the STANDBY indicator turns on, INITIALIZE flashes on the display and then STANDBY indicator blinks. The unit will not come out of standby mode. User manual says that this can be caused by incorrect voltage or a low impedance on the speakers.
How do you turn off a standby led?
Unplug power, wait for STANDBY led to turn off – then wait another five minutes. Plug in the power. As soon as the STANDBY indicator turns on hold the CMT- SBT100B stop [square] button and simultaneously press the remote (RM-AMU171) VOL+ button. You have to be ready to do this before the STANDBY indicator starts to blink.)
Why does my speakers not come out of standby mode?
Problem: On power-up the STANDBY indicator turns on, INITIALIZE flashes on the display and then STANDBY indicator blinks. The unit will not come out of standby mode. User manual says that this can be caused by incorrect voltage or a low impedance on the speakers.
For short breaks, simply turn down the volume control (or mute switch if you have one) and don’t use the standby switch, so there is not that nasty pop in the house sound system that could damage speaker drivers. If the time between sound check and performing is longer than 20 minutes, turn the amplifier completely off.
Why do you need a standby switch for a guitar?
The tubes used in guitar amps are the same type tubes used in Grandma and Grandpa’s old tube radio receivers, TV’s and record players, etc., which you never see with standby switches, do you? Therefore, why would a guitar amplifier be different than these other devices? Because they are not!
Why does my ksw-10 not come out of standby mode?
I have a KSW-10 that does not come out of standby mode when the receiver is powered on, The on/off indicator light that’s in front of the unit remains red (instead of turning green as it should). I can hear some faint bass sounds coming off it, which would indicate that it’s getting a signal.
Why is my subwoofer not coming out of standby mode?
One thing you might try is turning down the volume on the subwoofer and then turning up the volume in the receiver….this will send a hotter signal from the receiver to the subwoofer. You can also turn down the levels of the main speakers too.
