When does the DSC light come on and off?

Finally, your DSC light will come on when the system is in use. Unlike when there’s a problem in the system, the light will flash on and off repeatedly when this is happening. Additionally, you’ll feel your vehicle applying the brakes to specific wheels to help you maintain control of your vehicle.

Where can I Find my DSC security system?

Identify My Security System. Your DSC Security System is made up of a DSC control panel, one or more keypads and various sensors and detectors. The control panel, which is a metal cabinet, will be mounted out of the way in a utility closet or in the basement. The metal cabinet contains the system electronics, fuses and back up battery.

Where is the reset button on a DSc alarm?

This button is usually located on the bottom right side of the keypad. Hold it down for at least 2 seconds to disengage the alarm. You will notice the lights on the alarm change from red to green to signal that the alarm has been reset. This also helps to reset the low battery light once the power has been restored.

Why does my DSC alarm keep ringing when no power is on?

This is the most common reason for DSC alarms to unexpectedly ring. Check if the lights on the property are working to ascertain if the power is currently on. If the power is out and the alarm is ringing, this indicates that the batteries in the alarm system are dead and need to be replaced.

Why is my DSC alarm light still showing?

Was the Trouble light still showing before they left, its their responsibility to clear this before leaving site. Because they didn’t they should come back and fix this for no further charge. It sounds like a device is shorting the keypad bus or a wire has come adrift.

What is the bus on a DSc alarm?

The bus is the keypad bus, ie the data and clock wires that connect the keypad to the controller. Also on this bus are the zone expander cards and GSM unit… Either the problem is in in the controller or keypad (so by just powering the panel up with the keypad only we can eliminate this if it no longer selve arms.

What are the zones on my DSC alarm?

I then went into programming 903 and saw: Keypad8 (which I have), Zones 9-16 (which is right), Zones 17-24 (also right) and Zones 25-32 (which is NOT right), PC5132 (the remote alarm trigger I assume, which is right). So I entered programming 902, and back to 903 and the Zones 25-32 was gone.

Is the DSC alarm capable of arming and disarming?

I know the DSC has an automatic arm/disarm feature, and I have confirmed with the installer that this is no enabled. I also have an sms module (which I know is capable of arming and disarming the system), but it has no sim inserted and is thus not operational.