What should I know about car audio installation?

Topics range from basic system installation (head units, amplifiers, speakers, etc.) and mobile security (car alarms and remote start) to subwoofer box design and fiberglass fabrication. If you’re interested in custom fabrication and car audio installation be sure to check out what we have to offer.

Can a car stereo be used out side of the car?

We get asked a lot if car audio equipment can be used out side of the car and how this can be done. In short, yes this can be done, you’ll need a power converter that takes 120 AC Voltage and outputs 12 Volts DC to power your car audio equipment. Use this to charge a car battery if you need portability.

Do you need a car speaker for a home stereo?

But you do need to make sure your home stereo unit can handle the lower impedance of most car speakers. The typical car speaker is four ohms and most home receivers are designed for eight ohms. You would either need a receiver capable of driving four ohms or you would need to wire a pair of identical drivers in series to get eight ohms.

How many ohms does a car speaker need?

This is especially true of speakers since they are passive devices. But you do need to make sure your home stereo unit can handle the lower impedance of most car speakers. The typical car speaker is four ohms and most home receivers are designed for eight ohms.

We get asked a lot if car audio equipment can be used out side of the car and how this can be done. In short, yes this can be done, you’ll need a power converter that takes 120 AC Voltage and outputs 12 Volts DC to power your car audio equipment. Use this to charge a car battery if you need portability.

Do you need power converter for car audio system?

In short, yes this can be done, you’ll need a power converter that takes 120 AC Voltage and outputs 12 Volts DC to power your car audio equipment. Use this to charge a car battery if you need portability. Sonic Electronix always strives to be the premiere online shopping destination for car electronics and other consumer electronics.

How do you test a car stereo at home?

Get the black ground wire from the harness and strip it and connect it with the black from the PSU. If done correctly you can now test out the unit. Plug in power to PSU and the harness to stereo. It should power on if done correctly. Do as I say, not as I do. I measured the stereo and then roughly measured on the box.

How many speakers do you need for a car stereo?

Holes for the wires are also a necessity. Size depends on wire thickness. Put everything in the box and if done right should come out good. (Unlike mine.) You can run as many speakers as allowed by your headunit. I have 4 extra Sony XPLODs laying around but only wanted 2.