What does it mean when it says decoder off?

The DECODER OFF message is purely an information message. It can mean one of two things – a two channel source is input or there is no input. In either case the receiver would not need to turn on a decoder to play sound. Just one bent or damaged cable or connector can cause a loss in picture and/or sound.

What does PCM mean Yamaha receiver?

Pulse-Code Modulation (PCM) and the Dolby Digital® technology refer to different types of digital audio recordings. PCM is the conventional method for converting analog audio into digital audio. The PCM audio recorded on DVD is a two-channel digital, stereo audio track.

What does PCM mean on a receiver?

Pulse-Code Modulation
Pulse-Code Modulation (PCM) and the Dolby Digital® technology refer to different types of digital audio recordings. PCM is the conventional method for converting analog audio into digital audio. The PCM audio recorded on DVD is a two-channel digital, stereo audio track.

Why does my receiver show PCM?

PCM usually means the receiver is set to ‘pass through’ and the source device is doing the decoding. If the source (ps3/blu ray etc) is also set to pcm and its a 5.1 audio track you would still get 5.1 out of your speakers.

Why does my Yamaha decoder keep going off?

Well I have seen this a few times on the site, and it was due to the HDMI Inputs being faulty and the Yamaha not receiving a signal, thus giving the “Decoder OFF” message. In that case, the unit needs to be sent out to Yamaha for them to replace the HDMI Inputs, and check the 5 volt Bus Power coming into the processor.

Why is my decoder not loading the menu?

You might switch on your decoder but it simply loads till infinity but refuses to enter the menu. Some of these might arise because of minor imperfections that you can easily rectify by following these steps: ₹ Unplug the power cord from the decoder for at least 10 minutes.

How are error codes used in digital communication?

They are mainly used to correct double errors and burst errors. Hence, these are a few error correcting codes, which are to be detected at the receiver. These codes prevent the errors from getting introduced and disturb the communication. They also prevent the signal from getting tapped by unwanted receivers.

What to do if your decoder won’t scan?

After releasing the P+ button, press -++- in quick succession and your decoder will be able to scan once again. It will also be ready to complete the installation wizard successfully. The information provided should recommendedly be done only by an approved installer.

Is there a way to decode an error code?

In most cases users are searching the web for pages dealing with the error code. Also Stop codes issued in a blue screen or errors shown in device manager are cryptic. Unfortunately there are also many error sources. So let’s take a look how to proceed and decode error codes.

Well I have seen this a few times on the site, and it was due to the HDMI Inputs being faulty and the Yamaha not receiving a signal, thus giving the “Decoder OFF” message. In that case, the unit needs to be sent out to Yamaha for them to replace the HDMI Inputs, and check the 5 volt Bus Power coming into the processor.

When does the decoder off message come back on?

It is made most noticeable by the sub. At the same time as the noise from the speakers I see a “Decoder Off” message on the amp momentarily. After the message sound from the playing device comes back on and the message goes away. The whole thing takes under a second.

How to decode Windows Device Manager error codes?

Device errors will be shown on general tab. To decode such an error code, open this Microsoft device manager error codes website. The site documents all error codes related to Windows device manager. All system errors with error codes between 0 (0x0) and 15999 (0x3e7f) are decoded in the Microsoft web site System errors 0 – 15999.