Is there a master code for the DSC 1500 alarm?

I have a DSC 1500 alarm at home. I tried to change my passcode but I found out I do NOT have the master code/ installer code. I tried some standard codes (like 1234, 1500, 1550) but no luck.

How to remove the lockout on DSC 1500?

Using the hardware default wipes out _everything_except_ the installer code if the lockout feature was set. 1. With power on, short default pins and type * 8 0000 2. Remove short from default pins and press 91 to remove the lockout. 3. Press 20, then 1500, then press # #.”

How to reset to factory doityourself DSC 1500?

1. disable the communicator and turn the eol back off: 12 1 5 (you will see the corresponding LEDs turn on). Press #. 2. Correct your zones: 11 xx xx xx xx xx xx (xx being the 2 digit code for the zone type for each of your zones.) Press # until you exit programming.

What is the master code on an alarm?

A master code is used by the home security alarm installer and each one is usually unique to its installer. The master code is a four-digit code used to arm and disarm the system, as well as for programming additional access codes and changing other features.

How to reset DSC installer code to 1500?

“DSC PC1500/1550 Installer lockout removal (note: this only works on PC1500/1550 and not all models of those): To reset the Installer’s code to 1500: 1. With power on, short default pins and type * 8 0000. 2. Remove short from default pins and press 91 to remove the lockout. 3. Press 20, then 1500, then press # #.”.

Where is the master code on a DSc 1500 alarm kept?

The master code is kept by the installation company in the event that it is needed in the future. You should also write down your master code in a safe place just in case you need to access it.

A master code is used by the home security alarm installer and each one is usually unique to its installer. The master code is a four-digit code used to arm and disarm the system, as well as for programming additional access codes and changing other features.

Which is version of the PC1500 did you get?

Some early versions of the PC1500 did not have the audible exit delay feature. Which version did you get? (it’s on the main IC chip in the middle of the board) If you have one of the later models, in programming location 34 turn on option 1 & 4. You may need to set the exit delay shorter.