How to turn off sound on str-dn1080?

Check that all connecting cables are inserted to their input/output jacks on the receiver, speakers and the devices. Check that the receiver and all devices are turned on. Check that MASTER VOLUMEon the receiver is not set to [VOL MIN]. Press SPEAKERSon the receiver to select a setting other than [SPK OFF].

How to fix no sound and digital blinking on my pioneer?

Disconnect then reconnect the HDMI cable between the Cable Box and the Pioneer receiver, making sure it is secure on both ends. Then plug the Cable Box back into power and once rebooted turn everything back on and select the CBL Input on the Pioneer. The sound should be restored and the Digital light no longer blinking.

Why does my Marantz receiver have a flashing light?

The flashing light is an indication that your receivers have gone into protection mode. This can be caused by a multitude of things including speaker wire shorts and or by the receiver overheating brought about by pushing the receiver too hard or trying to drive hard to drive speakers.

What to do if your home audio device is flashing?

Turn off the home audio device, and remove all speaker wires from the back. Then turn the device back on and check if the issue is resolved. If it is still having the same issue, turn off the device again leave it off for at least 30 minutes before turning it on again.

Check that all connecting cables are inserted to their input/output jacks on the receiver, speakers and the devices. Check that the receiver and all devices are turned on. Check that MASTER VOLUMEon the receiver is not set to [VOL MIN]. Press SPEAKERSon the receiver to select a setting other than [SPK OFF].

Why does my pioneer TV have no sound?

The cable box needed to be reset in the first place, but you reset the receiver to factory defaults instead. That is why when you rebooted the cable box, the sound cam through the TV speakers instead of the receiver. So, you need to set the receiver up, just like you did when the unit was brand new.

Why is the digital light blinking on my pioneer?

Then plug the Cable Box back into power and once rebooted turn everything back on and select the CBL Input on the Pioneer. The sound should be restored and the Digital light no longer blinking. 1) Replace the HDMI cable between the cable Box and the receiver.

Turn off the home audio device, and remove all speaker wires from the back. Then turn the device back on and check if the issue is resolved. If it is still having the same issue, turn off the device again leave it off for at least 30 minutes before turning it on again.