How do I Turn Off the pioneer receiver?

The Pioneer receiver and the Panasonic TV are the real clues here. When turning off one turns off the other, it comes down to a setting in each: In the Pioneer HDMI menu, turn off control. In the Panasonic Viera Link menu, turn off control (both power on and power off).

What should I do about my pioneer sx-1050 receiver?

Pioneer SX-1050 Receiver Repair And Restoration This Pioneer SX-1050 will power up but there is no output to the speakers. This Pioneer SX-1050 repair and restoration will include cleaning the pots and switches. Some disassembly is always needed to do this job.

Why is AnyNet not working on my pioneer TV?

Anynet+ is working on and CEC is actived on the Pioneer receiver, and sometimes I cannot control the volume anymore, it disconnects and the TV does not recogize my Pioneer receiver anymore. 1 Solution is to unplug/plug the tv. 04-05-2018 09:55 AM in Hi, thanks for feedback.

When to replace filter capacitors on pioneer sx-1050?

Same story on the power amplifier assembly, those 40+ year old electrolytic capacitors need to be replaced. Be careful with the bias transistors shown below that attach to the heatsinks. The wires can break very easily. The two 22,000uf, 80 volt original filter capacitors will be replaced in this Pioneer SX-1050 solid state receiver.

How much does a pioneer sx-1010 receiver cost?

It measures 20 1/2″ x 17″ x 7″ and weighs in at around 50 pounds. The SX-1010 retailed for around $700 when new which is over $3000 in 2015 dollars. So, it was not considered a budget minded receiver by any means. This receiver is no slouch.

Which is the most powerful pioneer TV receiver?

And the first of these Monsters was Pioneer’s top-of-the-line Receiver for 1974, the SX-1010. On it’s release was the most powerful receiver in the world!

Why does my pioneer reciever only have one channel?

Oh – and the Velodyne is BRILLIANT! I hade something similar happen a few years back.There was no output from one channel when listening in stereo ( contradiction in terms there ) however when multi channel was selected the dead channel now burst into life .Iirc it was a blown ic.

When did the Akai aa-1010 stereo receiver come out?

Infact this is the baby of the series being first produced in 1976. Looking at the internals it’s not awfully complex either. Taking cues from the Yamaha receivers of the day, it’s brushed aluminium faceplate is complemented by a faux vinyl woodgrain veneer built on a plywood casing. It’s simply a nice little performer with good looks to boot.

Can a pioneer TV receiver send sound signals?

The passthru function works fine – so the receiver will send sound signals to the TV if I use passthru mode. Not sure what to do. I don’t think it’s covered under warranty anymore.

Why is my pioneer VSX 933 sound cutting out?

Pioneer VSX 933 doing the drop out whilst playing any sort of input. No option for 8ohm all new cables. I’m getting to the point of tossing it on the lake. Pioneer VSX 933 doing the drop out whilst playing any sort of input. No option for 8ohm all new cables. I’m getting to the point of tossing it on the lake. Click to expand…

What does digital safety do on a pioneer AVR?

Then there is also a “Digital safety” option on some Pioneer AVRs and if it is switched to on, the receiver will switch off under any strain or duress. The manual will show you how to disable it as it’s a combination of buttons to do it, I think you scroll between 6/8ohms, Digital safety on/off and reset. Best of luck.