How do I reset my Laview DVR?

Hold down the button, with the power still disconnected. While still holding the button down, plug power into the camera and continue to hold the button for 30 seconds. After 30 seconds from the power being plugged in, release the reset button and the camera should reboot and be set back to factory defaults.

Is there a way to reset your DVR password?

Click below to easily reset your DVR/NVR password. Forgot your password to login to the App? Click your App below to reset the password. Article is closed for comments.

Why does my PSS keep locking my DVR?

The reason is when you open PSS the software will attempt to connect to the DVR and if you don’t have the password correctly in the software then it will lock the account. Once you have change the password in the software make sure you click OK in the username window then OK again to close the device settings window.

What can I do if my DVR is not working?

You have two choices: you can either attempt a home fix, or you can dispatch the DVR to the data recovery experts at Gillware. It all depends on how critical keeping the CCTV recordings or information archives that reside on the internal hard disk.

Is there a way to reset the clock on a DVR?

Some DVR models allow you to reset the clock to factory default by removing the battery for a few minutes. This procedure works for some old Dahua DVR models and Z-mode DVR. Battery removal time may vary, some technicians report that it is sometimes necessary to wait up to 6 minutes for the card to fully discharge and reset the DVR’s clock.

What to do if you forgot your DVR password?

Note : i already tried to remove the battery and turn on the DVR but the DVR still keeping the old password, imagine that turn on the DVR without battery for one day and turn it off for one day but still keeping the old password, here is a snapshot of its motherboard

The reason is when you open PSS the software will attempt to connect to the DVR and if you don’t have the password correctly in the software then it will lock the account. Once you have change the password in the software make sure you click OK in the username window then OK again to close the device settings window.

Can you use the admin password on a DVR?

At this point you can only use the admin username and password from the DVR due to the fact that the other 2 usernames on the DVRs will only work locally at the unit and not from a software. If you want to use another user then you will need to create it in the DVR and assign it to the admin’s group.

What to do if you lost your h 264 DVR password?

If you are unlucky and lost the password for a generic H 264 DVR, I will list some ways to get around the problem, check which one may work for you. Here are the ways you can recover from a lost password. 1. Use the DVR factory default password 2. Use a DVR password generator 3. Update the firmware and reset the DVR 4.