How do I reset my DSC yellow light?
How do I reset my DSC yellow light?
Press the ‘7’ key and you will receive a number corresponding to the affected zone. The indicated zone is reading a low battery condition and needs a replacement battery. Replace the battery in the contact and the condition will clear.
What does the yellow triangle on my alarm mean?
trouble condition
The yellow triangle means that your alarm system is experiencing a trouble condition. This could be caused by a number of different possible factors, such as a low battery, an activated tamper or communication problems. Only certain alarm systems use a yellow triangle to indicate a trouble.
How to acknowledge and check a trouble on DSC power series?
How to Acknowledge and Check a Trouble Condition DSC Power Series PC1616, PC1832 and PC1864 1 Press the # key to silence the beeping that accompanies the trouble. 2 Should the Trouble Condition light be active on your system, Press * 2 to enter the Trouble Condition Menu 3 The Trouble Light will flash
Is there a problem with the powerseries control panel?
possible trouble conditions that can occur on any PowerSeries control panel (Power432, Power632, Power832 and Power864). LED Keypad, LCD Fixed-Message Keypad To view a trouble condition, press [*][2]. The trouble light will flash. Refer to the chart below to determine the trouble condition(s) present.
What are the trouble codes for DSC alarms?
Understanding DSC Alarm Trouble Codes. 1 Service Required (press [1] for more information) 1.1 Low Battery (main battery in panel) 1.2 Bell Circuit. 1.3 System Trouble. 1.4 System Tamper. 1.5 Module Supervision. 1.6 RF Jam Detected. 1.7 PC5204 Low Battery. 1.8 PC5204 AC Failure.
What causes a problem on a DSc keypad?
From time to time, conditions may arise which cause what is known as a ‘trouble’ condition on the keypad. Trouble conditions are wide ranging and can be anything from a low battery to a power failure to a communications failure.
possible trouble conditions that can occur on any PowerSeries control panel (Power432, Power632, Power832 and Power864). LED Keypad, LCD Fixed-Message Keypad To view a trouble condition, press [*][2]. The trouble light will flash. Refer to the chart below to determine the trouble condition(s) present.
How can I tell if my DSC alarm is in trouble?
Your keypad will then display a trouble code number or illuminate a certain zone, which has a corresponding meaning in the trouble code table in the User Manual. However, if you use DSC model PC4020, which has an LCD keypad with fixed displays, instead of displaying numbers, it will spell out the trouble condition.
From time to time, conditions may arise which cause what is known as a ‘trouble’ condition on the keypad. Trouble conditions are wide ranging and can be anything from a low battery to a power failure to a communications failure.
