How do I know if my DSC alarm is not working?

How to Acknowledge and Check a Trouble Condition DSC Power Series PC1616, PC1832 and PC1864

1. Press the # key to silence the beeping that accompanies the trouble.
2. Should the Trouble Condition light be active on your system, Press * 2 to enter the Trouble Condition Menu.
3. The Trouble Light will flash.

How do you test a DSC alarm sensor?

How to Test Your Keypad Sounder and Siren on Your DSC Security System (excluding smoke detectors):

1. Press *6 Then Enter Your Master Code.
2. Press 4.
3. This will activate all keypad sounders, sirens and keypad lights for 2 seconds.
4. The Ready, Armed and Trouble Lights will flash for the duration of the test.
5. Press # to Exit.

Why does my DSC alarm keep ringing when no power is on?

This is the most common reason for DSC alarms to unexpectedly ring. Check if the lights on the property are working to ascertain if the power is currently on. If the power is out and the alarm is ringing, this indicates that the batteries in the alarm system are dead and need to be replaced.

How to troubleshoot problems on the DSC home security system?

Check your home’s electricity and breakers. Check the home phone lines for a dial tone if 3 or 4 is lit up or displayed. These are both indicators of an interruption in the phone line connected to the system. If you have recently changed to cable telephone or have had DSL installed, contact your security company for assistance.

Where is the reset button on a DSc alarm?

This button is usually located on the bottom right side of the keypad. Hold it down for at least 2 seconds to disengage the alarm. You will notice the lights on the alarm change from red to green to signal that the alarm has been reset. This also helps to reset the low battery light once the power has been restored.

How can I Stop my DSC security system from beeping?

Press the pound key (#) to stop the security system from repeatedly beeping. Check to see if the “System” or “Trouble” light is illuminated. Press the star key (*) and then press the number 2 key. See if a number is displayed on the screen or if a zone number is illuminated.

How to disarm DSC power 832 Zone 1 light?

Re-connect AC power. (Battery power will NOT default the panel.) Go to a keypad, and verify that the Zone 1 light is lit. Remove AC power, and reconnect the original wiring. Reconnect AC and battery power. The default master code is 1234, and can now be used to arm and disarm the DSC Power 832 system.

What does light mean on DSC power832 problem?

Light 4 = General System Tamper (Check Tamper on External Modules) Light 5 = General System Supervisory (Enter programming and enter 902) Light 6 = 5204 Power Supply Module Low Battery

What is the master code for DSC power 832?

The default master code is 1234, and can now be used to arm and disarm the DSC Power 832 system. Get a copy of the programming manual to complete installer programming of the system, and enter the user codes you prefer. You can find links to free DSC manuals on my alarm system manual sources page.

How can I tell if my DSC power series is in trouble?

Press the number corresponding to the trouble condition to view the additional information. To view a trouble condition, press [*] [2]. The trouble light will flash and the LCD will display the first trouble condition present. Use the arrow keys to scroll through all trouble conditions present.