How do I add a wireless zone to my DSC?

How do I program a wireless zone on the DSC 1616, 1832, and 1864 systems?

1. Enter section 898.
2. You will now trip the first wireless device that you want to add.
3. Check that the ESN on the device and the keypad match and then press *.
4. You will now need to enter a zone number.
5. Then the system will ask for a zone type.

How do wireless motion sensors work?

Wireless motion detectors – or motion sensors – operate using infrared sensors. These detect any movement within their surveillance scope by picking up on the infrared radiation that’s emitted from living things. These infrared sensors are also often referred to as Passive InfraRed (PIR) sensors.

How do I program a wireless zone on the DSC?

If you get a long beep and the screen still says enter section, you will have to use section 804. Enter section 898. The screen should display Wireless Enrollment Mode. If it does not, skip to part B. You will now trip the first wireless device that you want to add. You can do this by opening and closing the contact or tampering the device.

How to enter wireless enrollment mode on DSC?

If you get a long beep and the screen still says enter section, you will have to use section 804. Enter section 898. The screen should display Wireless Enrollment Mode. If it does not, skip to part B.

How to program a wireless zone on the DSC 1616, 1832, and 1864?

How do I program a wireless zone on the DSC 1616, 1832, and 1864 systems? There are 2 options to enroll wireless devices. The best and easiest way is auto-enroll with section 898. This is not available with all configurations however. The easiest way to tell if it is available is to try going to 898.

Is there a way to enroll wireless devices?

There are 2 options to enroll wireless devices. The best and easiest way is auto-enroll with section 898. This is not available with all configurations however. The easiest way to tell if it is available is to try going to 898. If you get a long beep and the screen still says enter section, you will have to use section 804. Enter section 898.

Do you need a wireless remote to use a DSc sensor?

Below you will find DSC’s offerings for wireless sensors as well as wireless keychain remotes and panic buttons. A 5132-433 wireless receiver OR a keypad with a wireless receiver built in is required to use these sensors / remotes. Note: A few two way wireless items are only for use with the two way capable DSC Alexor.

How do I program a wireless zone to a DSc powerseries neo?

You can program a wireless zone to a DSC PowerSeries NEO by using option [804] within panel programming. The system must have an added wireless transceiver to support wireless sensors from the DSC PowerG lineup. These are the only wireless sensors that can be used with the system.

How to program a wireless zone on the DSC 1616?

You can do this by opening and closing the contact or tampering the device. This will cause the ESN of the device to broadcast to the receiver. The screen should display the 6 digit ESN followed by Confirm ESN. Check that the ESN on the device and the keypad match and then press *. You will now need to enter a zone number.

Are there any add ons for the DSC Alexor?

Lastly, DSC has some wireless add-ons to enhance your system. They offer the DSC WT4911B outdoor wireless siren with strobe and the DSC WT4901 indoor wireless siren. These sirens can be used with the DSC Alexor and DSC Impassa wireless alarm systems. Another add-on would be the DSC WT5500 wireless alpha-numeric keypad.