Can You factory reset a Yamaha RX v679 display?

Factory reset is my last attempt at sorting it before sending it for repair Thanks. To do the factory reset you need to be able to see the screen or at least know what order to press the buttons. Factory reset is my last attempt at sorting it before sending it for repair

How to connect a Rockville EQ to a Yamaha rx-v567?

How to connect a Rockville EQ to a Yamaha RX-V567 Natural Sound AV Receiver/Amp with Polk Audio Surround speakers Solved! Dont quite understand yamaha YAS 108 configuration

Why does my Yamaha DSP make no noise?

If you want to finalise that test, simply play the test tones in the in-built speaker setup software (it’s called YPAO for Yamaha), if you do not hear any noise – it’s faulty. This ‘no sound’ fault typically comes from a fault around the DSP, if you have tested with headphones or a ‘line out’ and head no noise.

What to do if your Yamaha receiver has no sound?

Failing that, you can do a rudimentary test by baking one of the chips on the HDMI board with a 50W halogen globe for a few seconds and then turning the unit on to see if the sound returns for a brief period. I do not suggest this before exhausting the warranty and service agent avenue.

What’s the problem with my RX v3900 speakers?

I believe the issue is with the speakers I’m using. They’re 60 Watt RMS and the RX-V3900 is putting out 140 watts RMS per channel if I’m not mistaken. Again, if I’m not mistaken it’s overloading the speakers.

What to do if there is no sound from an AV receiver?

If the sound comes normally, please change other HDMI cable. If still no sound output from the AV Receiver/Sound Bar even after checking above points, please confirm if the AV Receiver/Sound Bar and the TV have the HDMI Control function. Was this answer helpful? Thank you for your feedback!

How long is the speaker wire on my rx-v800?

There are a couple reasons I’m skeptical about the speaker wire being the culprit. Firstly it’s brand new wire and the section I’m using for testing is about 6 feet long. So any shorts should be fairly easy to spot visually. Secondly, I was using the exact same speaker wire and the exact same speakers with an RX-V800 just days before with no issue.

What do I do if my sound is disabled by mistake?

Check your device properties to make sure that your devices have not been disabled by mistake. Select Start > Settings > System > Sound . Select your audio device, and then select Device properties. Be sure to select Device properties for both the output and input devices. Make sure the Disable check box is cleared for the output and input devices.